XSGZS 发表于 2020-6-17 15:27
您的回复着实让我惊喜了一下，按照您提供的方法，我尝试了两次，最终还是未能解决这个问题，现决定返厂了 ...

据我了解，同样的问题已经有3台机器出现了，不知是否个案，还是通病

derekchen0866 发表于 2020-6-16 22:02
不是恢复机器的出厂设置，而是单独初始化网络模块，以下是TEAC客服发来的操作指导：[How to reset networ ...

您的回复着实让我惊喜了一下，按照您提供的方法，我尝试了两次，最终还是未能解决这个问题，现决定返厂了。
再次感谢您的热心帮助。

XSGZS 发表于 2020-6-16 21:37
初始化试过了，不管用，看来只好寄希望于DCH了。

不是恢复机器的出厂设置，而是单独初始化网络模块，以下是TEAC客服发来的操作指导：[How to reset network board of NT-505]
- Turn off the power of unit once, and unplug LAN cable.
- Small hole above XLR(Lch) jack behind of unit is opened, and there is a reset switch for network board where is located further into this hole.
  Insert such as unstretched clip to this hole, and keep the pushing condition.
- Turn on the power of NT-505 with this condition, and keep pushing the reset switch as is for 30 seconds, then network board will be initialized.
- After 30 seconds or more, pull out the clip and so on, and turn off the power once, and reconnect the LAN cable and turn on the power, then check whether the unit would work correctly.
  * Even if 30 seconds will be passed, there is no change with keeping  Starting display. (There is not any notice that initialization was completed)

derekchen0866 发表于 2020-6-16 18:52
好像我已经回复过了？看情况是网络模块故障了，先初始化网络试试，如果问题依然存在，就只能返厂换新网络模 ...

初始化试过了，不管用，看来只好寄希望于DCH了。

好像我已经回复过了？看情况是网络模块故障了，先初始化网络试试，如果问题依然存在，就只能返厂换新网络模块了